User's Manual

Page 778 of 910 Voice Gateway Media Card maintenance using Element Manager
553-3001-365 Standard 4.00 August 2005
Verify Voice Gateway Media Card loadware and firmware
The following steps are required to verify and upgrade the card loadware and
IP Phone firmware:
1 Check the version of the loadware currently installed on the Voice
Gateway Media Card. Refer to Procedure 39 on page 420.
2 Check the version of the firmware that is currently running on the Voice
Gateway Media Card. Refer to Procedure 40 on page 423.
3 Download the most up-to-date version of the loadware and firmware files
from the Nortel web site. Refer to Procedure 41 on page 424.
4 Upload the loadware and firmware files using the File Upload system
utility in Element Manager. Refer to Procedure 42 on page 426.
5 Upgrade the Voice Gateway Media Card software. Refer to Procedure 43
on page 427.
6 Restart the Voice Gateway Media Card. Refer to Procedure 44 on
page 432.
7 Upgrade and distribute the firmware to the IP Phones on the Voice
Gateway Media Card. Refer to Procedure 46 on page 438.
Add another Voice Gateway Media Card
Follow the steps in Procedure 110 to add another Voice Gateway Media Card
to the system.
Procedure 110
Add another Voice Gateway Media Card to the system
1 Install and cable the Voice Gateway Media Card, as described in “Install
the hardware components” on page 312.
2 Go to the VxWorks shell. Configure the Voice Gateway Media Card as a
Follower using the ELAN network interface IP address and subnet mask.
Restart the card.
The card obtains the ELAN network interface IP address and subnet
mask.
3 In the Element Manager navigator, click IP Telephony > Nodes:
Servers, Media Cards > Configuration.