User's Manual

Installation and initial configuration of an IP Telephony node Page 337 of 910
IP Line Description, Installation and Maintenance
Configure IP address for the system active
ELNK Ethernet network interface (LD 117)
To configure the Call Server’s ELAN network interface IP address (active
ELNK), follow the steps in Procedure 20.
Procedure 20
Configuring the ELAN network interface IP address for the active ELNK
1 Go to LD 117.
2 Create host entries with the IP address on the ELAN subnet by entering
one of the following commands:
NEW HOST PRIMARY_IP xx.xx.xx.xx
NEW HOST SECONDARY_IP xx.xx.xx.xx (for Large Systems only)
3 Assign the host entry IP address to active and inactive ELNK interfaces
on the ELAN subnet by entering one of the following commands:
CHG ELNK ACTIVE PRIMARY_IP
CHG ELNK INACTIVE SECONDARY_IP (for Dual CPU only)
4 Verify the IP address for the Ethernet network interface by entering the
following command: PRT ELNK.
5 Enter the following command: Update DBS.
6 Go to LD 137. Check the status of the Ethernet network interface by
entering the command: STAT ENLK. If the ELNK network interface is
disabled, enable it by entering: ENL ELNK.
End of Procedure