Media Bay Module Installation Guide and Configuration Gui

Chapter 7 Command Line Interface (CLI) 75
R2MFC Media Bay Module Installation and Configuration Guide
Commands
The following section lists and describes the CLI commands for the available directories.
LOad directory
Table 18 includes the CLI commands for firmware download and card restart. The commands are
accessed from the LOad directory.
INfo directory
Table 19 includes the CLI command to display and print information for troubleshooting problems
in the field. The command is accessed from the INfo directory.
Table 18 LOad directory CLI commands
CLI command Description
RST Restarts card firmware regardless of current state.
There is no prompt to confirm the restart.
load y Configures the hardware to accept downloads
fload Downloads the firmware.
Table 19 INfo directory CLI commands
CLI command Description
Fwversion Displays the firmware versions and the state of the DIP switches.
SystTime Prints the current time and how long the load has been in-service.
ALarm Prints the status of the E1 alarms on both links.
ChannelSummary Prints a summary of all PRI and MFC channels currently in use; for example,
not in idle state