Media Bay Module Installation Guide and Configuration Gui

Chapter 6 R2MFC MBM maintenance 69
R2MFC Media Bay Module Installation and Configuration Guide
6 Record the switch settings from the old module.
7 Set the DIP switches on the new module to match the settings you recorded in the previous
step.
8 Refer to “Installing an R2MFC MBM” on page 34 to install the module in the media bay.
9 Refer to “Repeat steps 1 and 2 to attach the rubber boot to the other R2MFC co-axial cable.”
on page 37 to restore the system to operation.
Upgrading firmware
Normal installation does not require firmware download. A firmware upgrade can be required at
some point to incorporate bug fixes or new features.
The following items are required for a firmware download:
• firmware load file
• PC connected to the RS232 serial port of the R2MFC MBM through COM1
• PC program delivered by the supplier: Bload1.exe for COM1
Figure 28 on page 70 provides an overview of the process for upgrading R2MFC MBM firmware.
Note: The version of the firmware, running on an installed R2MFC MBM, is found by
using the
Fwversion command in the INfo directory of the CLI. See Chapter 7,
“Command Line Interface (CLI)” for details on the CLI.