Media Bay Module Installation Guide and Configuration Gui

Chapter 5 Configuring the R2MFC MBM 55
R2MFC Media Bay Module Installation and Configuration Guide
Figure 21 BCM Bus configuration for R2MFC MBM
6 Select Modules on bus > Module 1 from the navigation tree.
The Bus # - Module # Information frame displays. See Figure 22 on page 56.
7 Configure the parameters in the Bus# - Module # information frame. See Table 8 for
parameters and settings.
See Figure 22 on page 56 for an example of the screen layout for an R2MFC MBM configured
on Bus 06.
Table 8 Module configuration parameters
Parameter Setting
Module type PRI
Protocol Euro
Clock source Primary (if only one trunk
module in system;
otherwise, it depends on the
synchronization scheme of
the BCM)
Overlap receiving Y
Local number length According to BCM local
dialing plan (customer -
dependent)