Media Bay Module Installation Guide and Configuration Gui

50 Chapter 5 Configuring the R2MFC MBM
NN40010-300
2 Set the Config DIP switches to the appropriate country code and second dial tone setting that
coincides with your location.
See Appendix A, “Configuring DIP switch settings and definitions,” on page 91 for predefined
country code DIP switch settings and their specifications.
See “Turning on second dial tone” on page 58 for the procedure to turn on second dial tone.
The Config DIP switch settings are divided into the following parts:
• country or diagnostics - DIP switch 1
• country code - DIP switches 2 through 5
• second dial tone (on/off) - DIP switch 6
Figure 17 on page 50 shows the Config DIP switch layout.
Figure 17 Config DIP switch layout
3 Power up, or restart, the R2MFC MBM.
Creating a customized country code
If the R2MFC MBM required settings are not identical to any country code, customization can be
performed using the CLI through the serial port. Perform the following steps for configuring the
customized country codes:
1 Set the Config DIP switches to match the country code closest to customer requirements. See
Appendix A, “Configuring DIP switch settings and definitions,” on page 91.
2 Power up or restart the BCM.
Note: Mexico Config 1 country code is the factory default setting. It is
the setting used if an invalid country value is set, or if a custom profile is
selected that does not exist.
O
N
123456
123456
O
N
country
second
di al
tone
diagnostic
s
configuration
country