Media Bay Module Installation Guide and Configuration Gui

40 Chapter 4 Installing the R2MFC MBM
NN40010-300
Figure 12 How to remove a BCM400 R2MFC MBM
Removing an R2MFC MBM from the expansion unit
Use this procedure to remove an R2MFC MBM from the BCM expansion unit.
1 Power-down the BCM expansion unit system (see “Shutting down the system” on page 32).
2 Remove any cabling from the R2MFC MBM faceplate.
3 Remove the expansion unit front bezel.
4 Grasp the edge of the MBM ejector lever. Pull outward to eject the R2MFC MBM. Refer to
Figure 13.
Warning: Remove the R2MFC MBM after the system is powered down.
Grasp the edge of the
R2MFC MBM ejector lever