Media Bay Module Installation Guide and Configuration Gui

Chapter 4 Installing the R2MFC MBM 37
R2MFC Media Bay Module Installation and Configuration Guide
1 Slide the rubber boot onto the R2MFC transmit co-axial cable. See Figure 8 on page 37.
Figure 8 Sliding the rubber boot on to the R2MFC transmit co-axial cable
2 Connect the R2MFC co-axial cable to the correct location on the MBM. See Figure 9 on page
37.
Figure 9 R2MFC Transmit Co-axial cable connected to the MBM
3 Repeat steps 1 and 2 to attach the rubber boot to the other R2MFC co-axial cable.
Note: Rubber boots ensure that no ESD occurs on to the co-axial connectors.