Passport Module User Guide

74 Chapter 5 Managing the Passport 8672ATM Module with the CLI

209195-A

This section contains the following information:

• “Configuration commands,” next

• “Show commands” on page 82

Configuration commands

This section describes the CLI configuration commands available with the

Passport 8672ATM Module. There are three types of configuration commands:

• “Module commands,” next

• “1483 ELAN statistics” on page 75

• “Port commands” on page 77

Module commands

The module commands allow you to:

• Reset the module

• View ELAN statistics

• Display the image filename for the Passport 8672ATM Module.

The syntax is:

config atmcard

The required variable <atmslot number> is the slot number of the module in

the Passport 8600 chassis. Table 14 describes the parameters and variables for the

config atmcard command.

Note: If you replace one card with another type of card, Nortel

Networks recommends that you go to the root level of the CLI directory

before using any CLI commands.