Passport Module User Guide

145
Using the Passport 8672ATM Module
Appendix B
Factory defaults
Table 52 shows the default settings on the Passport 8672ATM Module as it comes
from the factory, as well as the management tool to change parameters.
For more information on factory defaults, refer to:
• Reference for the Passport 8000 Series Command Line Interface Switching
Operations, Release 3.1
• Reference for the Passport 8000 Series Command Line Interface Routing
Operations, Release 3.1
• Reference for the Passport 8000 Series Management Software Switching
Operations, Release 3.1
• Reference for the Passport 8000 Series Management Software Routing
Operations, Release 3.1
Table 52 Factory default settings for the Passport 8672ATM Module
Parameter Default Management tool
VPI bits 4 Device Manager
VCI bits 7 Device Manager
Scrambling Enabled Device Manager
Framing SONET Device Manager
Clock source Free-running Device Manager
Loopback mode Internal Device Manager
Encapsulation LLC-SNAP Device Manager
Bit rate UBR Device Manager
Traffic shaping Disabled Device Manager