Passport Module User Guide

132 Chapter 6 Configuring the Passport 8672ATM Module
209195-A
5 Click Enable.
6 Click Apply.
The IP Address tab is redisplayed.
7 Click Close.
Enabling OSPF routing
If the routing protocol is OSPF, to enable OSPF routing:
1 From the Device Manager menu bar, choose VLAN > VLANs.
The VLAN dialog box opens with the Basic tab displayed (Figure 52 on
page 120).
Table 41 on page 120 describes the fields in the VLAN Basic tab.
2 Click one of the VLANs.
3 Click IP.
Listen Enables or disables RIP reception on the specified
interface.
Poison Enables or disables operation of poison reverse on the
specified interface. If poison is disabled, split-horizon
operation is enabled.
AdvertiseDefaultRoute Indicates whether this interface should advertise a RIP
default route.
AcceptDefaultRoute Indicates whether this interface should accept a RIP
default route.
TriggeredUpdateEnable Indicates whether the RIP triggered update feature should
be enabled on this interface.
AutoAggregateEnable Indicates whether the auto aggregation feature should be
enabled on this interface.
AdvertiseWhenDown Indicates whether vlan state change should be notified to
layer 3 or not, provided the vlan is configured as routable
interface. Also used for single routable ports, in that case
the criteria for state is PortOperStatus.
Table 46 RIP tab fields (continued)
Field Description