Part No.
Copyright © 2000 Nortel Networks All rights reserved. April 2000. Trademarks NORTEL NETWORKS and Passport are trademarks of Nortel Networks. All other trademarks and registered trademarks are the property of their respective owners. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, Nortel Networks NA Inc. reserves the right to make changes to the products described in this document without notice. Nortel Networks NA Inc.
About this Guide This guide provides the following information: • Operational notes • Instructions for installing a Passport 8001PS AC Power Supply in an unoccupied bay of the Passport 8010 Chassis • Instructions for replacing an installed power supply in the Passport 8010 Chassis • Specifications for the power supply For more information about the Passport™ chassis, refer to Installing the Passport 8010 Chassis (part number 204518-B).
Installing a Power Supply Required tool: Phillips screwdriver 8958FA 8957FA 1. If necessary, remove the filler panel from a power supply bay. 2. Push the power supply firmly into the bay. Note: If you are installing a power supply in a new chassis, be sure to remove the bag of dessicant from the middle power supply bay. 8959FA 3. Tighten the retaining screws. 8960FA 4.
8964FA 5. Turn on the power switch. Note: In a chassis that requires more than one power supply (see “Operational Notes”), you must turn on both units within 2 seconds of each other. If you wait longer to turn on the second power supply, both power supplies will latch off. To correct this condition, turn off both power supplies, wait at least 30 seconds, and turn both power supplies on again within 2 seconds. Replacing a Power Supply Required tool: Phillips screwdriver 8972FA 1.
8963FA 3. Loosen the retaining screws. 9072FA 4. Lift the extractor lever to disconnect the power supply from the backplane. Pull the power supply out of the chassis. 9156FA 5. 4 Push the new power supply firmly into the bay. 9157FA 6. Tighten the retaining screws.
9158FA 7. Connect the power cord to the power supply and to a power outlet that is on a circuit with no other equipment connected to it. 9159FA 8. Connect each power supply in the chassis to a separate AC circuit. Turn on the power switch. Note: In a chassis that requires two power supplies (nonredundant configuration), you must turn on both units within 2 seconds of each other. If you wait longer to turn on the second power supply, both power supplies will latch off.
