Access Switch Quick Start Guide

Quick-Start Guide for Nortel Networks 5399 and 8000 Access Switches
10 300855-C Rev. 00
Task 7: Set Switch Parameters
Using the switch parameters gathered from Task1, configure the switch.
View the existing WAN parameters by entering
sho wan=all all. Set the WAN
parameters to be compatible with those provided by the telco. For information on
setting WAN parameters, refer to Managing Nortel Networks 5399 and 8000
Access Switches Using Command Line Interfaces.
Task 8: Configure Security
This section describes how to configure both ACP and RADIUS security regimes
and PPP setup. When configuring RAC security, you configure the security
regime before configuring PPP.
ACP Security
This section tells the user how to configure ACP security on a server and how to
setup the RAC to authenticate users. After setting up security on a Microsoft NT
server or a UNIX server, you must setup the RAC for authentication on the server.
Note: Make sure the WAN parameters are compatible with those provided by
the telco. The telco may temporarily disable lines connected to improperly
configured devices. For more information on WAN parameters, refer to Nortel
Networks 5399 and 8000 Access Switch Software Reference.
Note: If you are using another third party security regime, refer to the
Managing Nortel Networks 5399 and 8000 Access Switches Using Command
Line Interfaces and Installing and Administering the Config Utility.
Note: To configure ACP security, you must have selected ACP as the default
security regime during the software installation.