Access Switch Quick Start Guide

Quick-Start Guide for Nortel Networks 5399 and 8000 Access Switches
6 300855-C Rev. 00
Set the Network Addresses
This section uses the IP addresses established in Task 1. To set the network
addresses:
1. At the ROM monitor prompt, enter addr and respond to the prompts as
shown in the example. To accept the default shown in brackets, press the
Return key.
monitor:: addr
Enter Internet address::192.9.200.62
Enter Subnet mask [255.255.255.0]::
Enter Broadcast address::192.9.200.255
Enter preferred Load Host address::192.9.200.55
Enter Preferred Dump Host [0.0.0.0]::192.9.200.55
Enter Load/Dump Gateway address::192.9.200.1
Select type of IP packet encapsulation (ieee802/ethernet)
[<ethernet>]::
Load Broadcast y/n [y]::
2. After you enter the address path names, enter ad -d to verify the IP
address.
3. After you verify the IP address, set the operating image.
Note: For illustration purposes, this example shows a RAC on an Ethernet
network with the IP address 192.9.200.62. The host system address is
192.9.200.55. The router gateway address would be 192.9.200.1 for this subnet
to access other subnets.