Switch Installation Guide

Installing a Module

For details about the operation of modules, refer to the documentation that was shipped with each

module.

Required tool: Phillips screwdriver

1. Remove a filler panel from a module slot. 2. Make sure the inserter/extractor levers are

rotated away from the front of the module.

9058FA

9059FA

3. Align the module circuit board with the card

guides in the chassis. Slide the module into a

slot in the chassis until the module touches

the backplane connectors.

4. Rotate the inserter/extractor levers to seat the

backplane connectors.

9060FA

9070FA