Business Policy Switch User Guide

387
Using the Business Policy Switch 2000 Version 1.2
Appendix F
Default Settings
Table 74 lists the factory default settings for the Business Policy Switch 2000
according to the console interface (CI) screens and fields for the settings.
Table 74 Factory default settings
Field Default setting Appears in this CI screen
BootP Request Mode BootP Disabled “IP Configuration/Setup screen” on
page 155
In-Band Stack IP Address 0.0.0.0
(no IP address assigned)
In-Band Switch IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
Read-Only Community String public “SNMP Configuration screen” on
page 160
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
Link Up/Down Trap Enabled
sysContact Zero-length string “System Characteristics screen” on
page 162
sysName Zero-length string
sysLocation Zero-length string