Business Policy Switch User Guide

366 Appendix C Media dependent adapters
208700-B
Replacing an MDA with a different model
When replacing an installed MDA with another type of MDA, complete the
following steps to clear the switch NVRAM:
1 Power down the switch.
Remove the AC power cord from the power source.
2 Remove the installed MDA.
Loosen the thumbscrews and remove the MDA.
3 Cycle the switch power.
Power up the switch and wait for the Nortel Networks logo screen to appear
(approximately 10 seconds); then power down the switch.
4 Install the replacement MDA.
Be sure to firmly tighten the two thumbscrews on the MDA front panel.
5 Power up the switch.