Business Policy Switch User Guide

Appendix C Media dependent adapters 363
Using the Business Policy Switch 2000 Version 1.2
Figure 139 Removing a GBIC
2 If the GBIC has an extractor handle, grasp the handle and pull firmly to
remove the GBIC from the MDA’s Host port.
Cabling Specifications for GBICs
For more information about supported GBICs and for details about cabling
specifications, refer to the Gigabit Interface Converter (GBIC) Installation Guide
(part number 208723-A).
Installing an MDA
The Uplink/Expansion Module slot on the Business Policy Switch accommodates
a single MDA. The connection can be either an RJ-45 10/100BASE-TX MDA or
a fiber (100BASE-FX or 1000BASE-SX/LX) MDA with an SC or MT-RJ
connector.
To install an MDA into the Uplink/Expansion Module slot:
1 Unplug the AC power cord from the back of the switch.
Note: The MDAs are not hot-swappable. Power down the switch before
installing or removing an MDA.
9826FA