- Nortel IP Phone Mobile Communication Integration Guide

Adding an NRS Routing rule 47

Ensure that the correct service domain, L1 domain, and L0

domain are selected and click Add.

The View Gateway Endpoint Property page appears.

6 For Endpoint name, type a relevant endpoint name.

Example: MCG3100

For Endpoint description, type a relevant endpoint description.

Clear the Trust Node check box.

9 Ensure that Tandem Gateway Endpoint name is configured to

Not Configured.

10 Ensure that Endpoint Authentication Enabled is configured to

Authentication Off.

For SIP support, select Dynamic SIP endpoint.

For SIP transport, select the transport protocol type.

Type a value for the SIP port, or leave the default value of 5060.

14 Click Save.

15 Click Cut over.

The Cut over command is issued, and the database is placed

into a Switched over state.

In the NRS Manager Navigator, select System, Database.

The Database Web page opens. The Database status is

Switched over.

Select Commit.

The Commit command is issued, and the database is placed into

a Committed state.

--End--

Adding an NRS Routing rule

Use this procedure to create an NRS Routing rule to route calls to the

MCG 3100.

Procedure steps

Step Action

1 Log in to the ECM system.

2 Launch the NRS Element.

The NRS interface opens.

Nortel Mobile Communication 3100

Mobile Communication 3100 and Communication Server 1000 Solution Integration Guide

NN49000-315 02.01 2 October 2009