- Nortel IP Phone Mobile Communication Integration Guide

46 NRS configuration

Figure 8

NRS configuration task flow

Task ﬂow navigation

•

"Configuring gateway endpoints on the NRS" (page 46)

• "Adding an NRS Routing rule" (page 47)

• "Adding a User Endpoint" (page 49)

Conﬁguring gateway endpoints on the NRS

Perform the following procedure to configure the MCG gateway endpoints

on the Network Routing Service (NRS). You must perform this procedure

for each MCG node on the system.

On NRS redundant systems, perform all configuration on the primary NRS.

Procedure steps

Step Action

1 Open NRS Manager by doing one of the following:

In Element Manager, select Dialing and Numbering Plans,

Network Routing Service.

In Internet Explorer, enter the IP address of the NRS into the

address bar.

2 Select the Configuration tab.

3 Click set Standby DB view to switch from active to standby

database view.

4 Click Gateway Endpoints.

Nortel Mobile Communication 3100

Mobile Communication 3100 and Communication Server 1000 Solution Integration Guide

NN49000-315 02.01 2 October 2009