Nortel CallPilot Quick Start Guide

64 Appendix Conﬁguring phantom DNs

Enter LD 97.

At the REQ prompt, enter CHG.

4 At the TYPE prompt, enter SUPL.

At the SUPL prompt, enter xxxx, where xxxx is the loop number,

preﬁxed with N to designate the loop as a phantom loop, or with V to

designate a virtual loop.

For Large Systems, xxxx = N0–N156 in multiples of 4.

For Small Systems, xxxx = N96 - N112 in multiples of 4.

To exit the overlay, enter ****.

—End—

Creating a phantom DN

Step Action

Connect to the PBX.

Enter LD 10.

Enter the appropriate values as described in the following table

to modify the system parameters. For prompts not listed in the

following table, press Enter to accept the default.

Table 19

LD 10 - Creating a phantom DN

Prompt Response Notes

REQ NEW

TYPE

500

TN aaa.bbb.ccc.ddd Terminal number, where aaa =

loop, bbb = shelf, ccc = card,

and ddd = unit.

CDEN

Card density supported by the

loop, where xx = DD for double

density, or 4D for quadruple

density.

xxxx

DN for CallPilot.

Nortel CallPilot

Quickstart Guide

NN44200-313 01.02 Standard

5.0 19 May 2008