Server User Manual

482 Appendix G Upgrade an ITG Trunk 1.0 node to support ISDN signaling trunks

Figure 157

Software download example

To verify the software upgrade on Leader 0, telnet to the IP address

of the Leader 0 card. Leader 0 is the only card that has an IP

address conﬁgured at this stage of the upgrade. Enter the following

command:

ITG> swVersionShow

Conﬁgure the ITG Trunk 2.0 data on the TM 3.1 ITG ISDN IP Trunk

application. "Conﬁgure IP Trunk 3.01 (and later) data in TM 3.1"

(page 236)

Transmit conﬁguration data to the upgraded ITG 8-port trunk cards

using normal ITG Trunk 2.0 installation procedures.

Upgrade Meridian 1 to Release 25 software.

—End—

Remove ITG Trunk 1.0 conﬁguration data from Meridian 1

Follow the steps in Procedure 84 "Removing the ITG Trunk 1.0 conﬁguration

data from Meridian 1" (page 483) to remove the ITG Trunk 1.0 conﬁguration

data from Meridian 1.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563 02.01 Standard

Release 5.5 21 December 2007