Server User Manual

ManualsBrandsNortel Networks ManualsServerNN43001-563

401

402

403

404

405

406

407

408

409

410

406 Maintenance

Command

Description

setLeader IP address, IP

gateway, subnet mask

The one command that does all the necessary actions to make

a Leader. Sets IP address, gateway, subnet mask, boot method

to static, and Leader bit in NVRAM.

Example: ITG> setLeader "47.23.45.67", "47.0.0.1", "255.255.240.0"

clearLeader

The one command that does all the necessary actions to clear

the Leader information in NVRAM and set the boot method to

use BOOTP, thus, making the card a Follower.

Example: ITG> clearLeader

Table 64

DSP commands

Command

Description

DSPReset DSP Number Reset the indicated DSP.

Example: ITG>DSPReset 0

DSPSelfTest DSP Number Run self-test on the DSP.

Example: ITG>DSPSelfTest 0

DSPNumShow

Print number of DSPs on IP trunk card.

Example: ITG>DSPNumShow

DSPPcmLpbkTestOn

Start PCM loopback test on the indicated DSP.

Example: ITG>DSPPcmLpbkTestOn

DSPPcmLpbkTestOff

Stop PCM loopback test on the indicated DSP.

Example: ITG> DSPPcmLpbkTestOff

DSPSndLpbkTestOn

Start Send loopback test on the indicated DSP.

Example: ITG> DSPSndLpbkTestOn

DSPSndLpbkTestOff

Stop Send loopback test on the indicated DSP.

Example: ITG> DSPSndLpbkTestOff

DSPRcvLpbkTestOn

Start Receive loopback test on the indicated DSP.

Example: ITG> DSPRcvLpbkTestOn

DSPRcvLpbkTestOff

Stop Receive loopback test on the indicated DSP.

Example: ITG> DSPRcvLpbkTestOff

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563 02.01 Standard

Release 5.5 21 December 2007