Server User Manual

ManualsBrandsNortel Networks ManualsServerNN43001-563

401

402

403

404

405

406

407

408

409

410

402 Maintenance

Command

Description

displayClear

Clear the maintenance display on the faceplate of the IP trunk

card.

shellPasswordSet

Change the default ITG shell password.

emodelSim

Allow user to interactively determine QoS score.

itgHelp

Show the complete command list. "?" also shows the list.

itgCallTrace

Shows call trace log.

tLanSpeedSet

Set the speed of the TLAN network interface.

tLANDuplexSet

Set the duplex mode of the TLAN network interface.

logout

Exit the shell.

PING

Test remote host is reachable:

PING<host><numPackets><option>

This command sends an ICMP ECHO_REQUEST packets to a

network host. The host matching the destination address in the

packets responds to the request. If a response is not returned,

the sender times out. This command is useful to determine if

other hosts or IP trunk cards are properly communicating with

the sender card. The <numPackets> parameter specifies how

many packets to send; if it is not included, ping runs until it is

stopped by Ctrl-C (which also exits the ITG shell).

Example: ITG> PING "47.82.33.123", 10

trap_gen

SNMP test alarm (one of each type) generation.

clearLED

Clear the LED display.

esn5PrefixSet

Set the esn5Prefix, default is "100":esn5Prefix<"char string">

esn5PrefixShow

Display the esn5Prefix character string.

routeAdd "host/ network IP

address", "IP Gateway"

This command adds a route to the network routing table. The

route is added to the host portion of the routing table.

Example: ITG> routeAdd "47.82.33.123", "47.82.33.1"

mRouteAdd "host/ network IP

address", "IP Gateway", "Subnet

mask", "ToS value", "flags"

This command adds multiple routes to the same destination in

the routing table. The route is added to the network portion of

the routing table. Multiple route entries for a single destination

are possible if entered with this command, as the ToS and

subnet mask values are used to distinguish between them.

Currently, "flags" should be set to "0".

Example: ITG>mRouteAdd "47.82.33.123", "47.82.33.1",

"255.255.255.0", 4, 0

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563 02.01 Standard

Release 5.5 21 December 2007