Server User Manual

ITG shell command set 401
Table 61
General purpose commands
Command
Description
cardReset
Perform a warm reboot of the IP trunk card. The card has to be
in the OOS state to use this command.
itgCardShow
Show card information.
ldrResTableShow
Show Backup Leader and Followers for a given Leader.
itgChanStateShow
Show state of channels (for example, busy or idle).
h323SessionShow
Show H.323 session information for each channel.
itgMemShow
Show memory usage.
ifShow
Show detailed network interface information, including MAC and
IP addresses.
IPInfoShow
This command will return the following IP information:
•
IP addresses (for both ELAN and TLAN network interfaces)
• default router (for both ELAN and TLAN network interfaces)
•
subnet masks (for both ELAN and TLAN network interfaces)
•
SNMP manager
cardStateShow
IP trunk card state (that is Unequipped, Disabled, Enabled).
serialNumShow
Print out IP trunk card serial number and PEC.
This command displays the same IP trunk card serial number
that is displayed from the system IDC command, and the
Product Engineering Code (PEC).
firmwareVersionShow
Print out firmware version number.
numChannelsShow
Print out number of available channels.
numNodesInFallbackShow
List the IP addresses of the IP Trunk 3.01 (and later) nodes that
are in fallback to the conventional voice circuit-switched network.
swVersionShow
Print out software version.
resetOm
Reset the Operational Measurement file timer.
logFileOn
Turn on logging.
logFileOff
Turn off logging.
logFileShow
Show if logging is on or off.
logStatus
Show if logging is on or off.
useM1ForRingBack
This command is used to turn off the local ring back generated
on the IP Trunk card. By default, the IP trunk card will generate
local ring back for out of band ring back. This command will only
be in effect until the card reset.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright © 2007, Nortel Networks
.