Manualshelf

Server User Manual

ManualsBrandsNortel Networks ManualsServerNN43001-563
241242243244245246247248249250
248 Install and configure IP Trunk 3.01 (and later) node
Subnet mask = 255.255.255.0
Subnet = 23.11.42.0
IP Trunk card TLAN IP = 23.11.42.121
Subnet mask = 255.255.255.0
Subnet = 23.11.42.0
23.11.42.0 = 23.11.42.0.
Therefore, the SNMP traps will be sent to the TLAN router.
WARNING
Nortel recommends the SNMP client (that is, the TM 3.1 PC) not
be put on the TLAN subnet.
Placing the TM 3.1 PC on the ELAN subnet is a more secure
configuration. Additionally, incorrectly configuring the SNMP trap
IP address can adversely affect routing on the IP trunk card, which
can prevent the IP trunk card from sending or receiving calls.
Procedure 22
Configuring SNMP Traps/Routing and IP addresses tab
Step Action
1
Click SNMP Traps/Routing and IPs tab. See Figure 56 "SNMP trap
addresses/Routing table IP addresses tab" (page 248).
Figure 56
SNMP trap addresses/Routing table IP addresses tab
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright © 2007, Nortel Networks
.