Server User Manual

226 Install and configure IP Trunk 3.01 (and later) node
Table 48
LD 16 NEW/CHG/OUT
Prompt Response Description
req
new/chg/out
type
rdb Route Data Block.
cust
0-99
tktp TIE Trunk Type.
M911P (NO)/YES M911 Trunk Type for MCDN Network.
M911_ABAN (NO)/YES Optional call abandon treatment:
YES = abandoned call treatment for route.
NO = no abandoned call treatment for route.
M911_TONE YES/(NO) optional call abandon tone:
YES = tone given on answer.
NO = silence given on answer.
ABTR (15)
Range 0-30
Timer (in minutes) to block the disconnect from being
tandemed across to the target node. Default value: 15
minutes. This timer value can be added in increments of
1 minute.
BRIP NO BRIP is set to NO by default, as this is not applicable to
911P routes.
DGTP PRI/PRI2 Valid responses for this prompt are PRI or PRI2 if M911P
prompt is set to YES.
MODE PRA Valid response for this prompt is PRA if M911P if prompt
is set to YES, and VTRK is set to NO.
IFC SL1 IFC is set to SL1 by default if M911P is set to YES. This
prompt is not configurable.
Table 49
LD 16 NEW/CHG/OUT for VTRK
Prompt Response Description
req
new/chg/out
type
rdb Route data block.
cust
0-99
tktp TIE Trunk type.
M911P (NO)/YES M911 trunk type for MCDN network.
M911_ABAN (NO)/YES Optional call abandon treatment:
YES = abandoned call treatment for route.
NO = no abandoned call treatment for route.
M911_TONE YES/(NO) YES = tone given on answer.
NO= silence given on answer.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright © 2007, Nortel Networks
.