Server User Manual

Cabling for the Media Card 32-port trunk card 213

Fit the screw through the secondary side of the Media Card 32-port

trunk card into the threaded hole in the bracket and tighten.

Fit the DCHIP PC Card NTMF29BA cable assembly through the

faceplate slot and push it home into the header.

Fit the DCHIP PC Card connector of the NTMF29BA cable assembly

into Port 0 (the upper socket) on the DCHIP card.

Fit the clamp over the PC Card connector and into the bracket.

Ensure that the cable is ﬁtted through the clamp, then secure it to

the bracket with the attached screw.

Make sure the eject button protrudes when the card is fully inserted.

Do not use excessive force when inserting the DCHIP PC Card.

—End—

DCHIP cable routing, Large Systems

NTMF29BA/NTND26AA cable routing

The NTND26AA cable from the MSDL forms a direct ﬂying lead connection

to the NTMF29BA cable from the DCHIP card. The cables must be routed

internally to the system along the cabling channels, as shown in Figure 46

"Large System DCHIP cabling setup: intra-column/cube" (page 214). The

NTND26 cable is available in various lengths.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563 02.01 Standard

Release 5.5 21 December 2007