Server User Manual

196 Install and configure IP Trunk 3.01 (and later) node
Install the NTCW84KA cable (for DCHIP cards)
Follow the steps in Procedure 9 "Installing the NTCW84KA cable" (page
196) to connect the NTCW84KA cable for DCHIP cards.
Procedure 9
Installing the NTCW84KA cable
Step Action
1
Connect the NTCW84KA cable see to the I/O panel connector (see
Figure 36 "NTCW84KA ELAN, TLAN, DCH, and serial cable" (page
197)).
Make sure to connect to the I/O panel connector that corresponds to
the left slot number of the DCHIP card.
2
Secure the mounting screw provided on the top of the Shielded
25-Pair Amphenol Connector to the I/O Panel filter connector in
order to tie the shield of the LAN cable to the frame ground for EMC
compliance.
—End—
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright © 2007, Nortel Networks
.