Network Card User's Manual

Installation procedures 77

The power source must not feed the power back into the DSL

through the RJ-45 wall outlet, only to the local ISDN BRI terminal.

The power adapter is normally supplied with the terminal.

Figure 28 "Connecting the ISDN BRI terminal to the S/T interface"

(page 78) illustrates an ISDN BRI terminal connection to an S/T

interface. Figure 29 "Connecting the ISDN network terminator to the

U interface" (page 79) illustrates an ISDN BRI terminal connection to

a U interface.

Enter the Static TEI at the terminal.

Note: Do not perform this step to assign Dynamic TEIs since

they are automatically assigned.

4 Enter the Service Proﬁle ID number at the terminal.

For detailed information about this procedure, refer to the terminal

user guide.

Repeat step 1 to step 4 for each ISDN BRI terminal.

—End—

Nortel Communication Server 1000

ISDN Basic Rate Interface Installation and Commissioning

NN43001-318 01.02 Standard

Release 5.0 20 June 2007