Network Card User's Manual

20 Installing ISDN BRI hardware

Procedure 2

Remove the module cover for card installation

Step Action

To remove the covers from the modules with unused card slots, follow the

procedure below. Refer to Figure 4 "Module cover locking latches" (page

20).

Use a ﬂat-blade screwdriver to unlock the left latch on the front of the

cover by turning the screw 1/4 turn clockwise.

2 Use a ﬂat-blade screwdriver to unlock the right latch on the front of

the cover by turning the screw 1/4 turn counterclockwise.

While holding the cover so it does not fall off, slide the latches toward

the center of the cover.

4 Pull the cover toward you and lift it away from the module.

Place the cover in a safe place away from the working area to avoid

damaging it.

Repeat steps 1 through 5 for each cover requiring removal.

—End—

Figure 4

Module cover locking latches

Nortel Communication Server 1000

ISDN Basic Rate Interface Installation and Commissioning

NN43001-318 01.02 Standard

Release 5.0 20 June 2007