Network Card User's Manual

102 Testing ISDN BRI functions

After the call-or iginating ISDN BRI terminal receives an

acknowledgment that the receiving ISDN BRI terminal is ready, the

call-originating ISDN BRI terminal can begin transmitting packet

data.

Verify that the transmitted data has been received successfully

by checking the transmitted information for accuracy. Read the

information on the screen or print it on the local printer.

Perform this test between two ISDN BRI terminals on the same MPH

for local transmission and between a system ISDN BRI terminal

and a remote ISDN BRI terminal over the Packet Switched Data

Network (PSDN).

5 Release the connection.

—End—

Procedure 40

Perform a B-channel Switched Virtual Circuit packet data transmission test

using an MPH

Step Action

From an ISDN BRI B-channel packet data terminal, dial the Network

Terminal Numbers (NTNs) as conﬁgured in LD 27. Establish an

active call connection.

After the call-originating ISDN BRI terminal receives an

acknowledgment that the receiving ISDN BRI terminal is ready, the

call originating ISDN BRI terminal can begin transmitting packet data.

3 Verify that the transmitted data has been received successfully

by checking the transmitted information for accuracy. Read the

information on the screen or print it on the local printer.

Perform this test between two ISDN BRI terminals on the same MPH

for local transmission and between a system ISDN BRI terminal and

a remote ISDN BRI terminal over the packet data network.

Release the connection.

—End—

Nortel Communication Server 1000

ISDN Basic Rate Interface Installation and Commissioning

NN43001-318 01.02 Standard

Release 5.0 20 June 2007