Computer Accessories User's Manual

ECM Upgrade Procedures 29

There are several procedures in this section. Perform the first procedure

based on your system configuration:

•

“1a: Upgrade Primary server without Backup server and less than

three or no Member servers” (page 29)

•

“1b: Upgrade Primary server without Backup server and less than

three or no Member servers” (page 29)

•

“1c: Upgrade Primary server with Backup server and three or more

Member servers” (page 30)

Then perform one or both of the following procedures as applicable to your

system configuration:

•

“Upgrade Backup ECM Security server” (page 31)

•

“Upgrade ECM Member server” (page 33)

This procedure describes upgrading the Primary ECM Security server from

Rls 5.00 to Rls 5.50 in a configuration with no Backup ECM server and

less than three or no Member servers associated with it.

1a: Upgrade Primary server without Backup server and less than three or no

Member servers

Step Action

There are no prerequisites for this procedure.

1 Open a command line interface session to the Primary ECM

Security Server through the serial port with the nortel account.

2 Perform the “Upgrading Nortel Linux base ” (page 54) procedure.

3 Open a command line interface session to the Primary ECM

Security Server through the serial port with the nortel account.

4 Install the following patches onto the Primary ECM Security

server using the “Patching Operation” (page 106) procedure.

•

MPLR25520

• MPLR25521

--End--

This procedure describes upgrading the Primary ECM Security server from

Rls 5.00 to Rls 5.50 in a configuration with a Backup ECM server and less

than three or no Member servers associated with it.

1b: Upgrade Primary server without Backup server and less than three or no

Member servers

Nortel Communication Server 1000

Linux Platform Base and Applications Installation and Commissioning

NN43001-315 02.09

29 October 2008