User's Manual
76 Chapter 6 Remote Node setup
N0115791
My WAN Addr Some implementations, especially UNIX derivatives,
require separate IP network numbers for the WAN and
LAN links and each end to have a unique address within
the WAN network number. In that case, type the IP
address assigned to the WAN port of your BCM50a
Integrated Router.
NOTE: Refers to local BCM50a Integrated Router
address, not the remote router address.
NAT Press [SPACE BAR] and then [ENTER] to select Full
Feature if you have multiple public WAN IP addresses for
your BCM50a Integrated Router.
SUA Only
Select SUA Only if you have just one public WAN IP
address for your BCM50a Integrated Router. The SMT
uses Address Mapping Set 255 (menu 15.1.255 - see
Figure 34).
Select None to disable NAT.
Address
Mapping Set
When Full Feature is selected in the NAT field, configure
address mapping sets in menu 15.1. Select one of the
NAT server sets (2-10) in menu 15.2 (see Chapter 9,
“Network Address Translation (NAT),” on page 89 for
details) and type that number here.
When SUA Only is selected in the NAT field, the SMT
uses NAT server set 1 in menu 15.2 (see Chapter 9,
“Network Address Translation (NAT),” on page 89 for
details).
2
Metric The metric represents the “cost” of transmission for
routing purposes. IP routing uses hop count as the cost
measurement, with a minimum of 1 for directly connected
networks. Type a number that approximates the cost for
this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good
number.
2
Private This determines if the BCM50a Integrated Router will
include the route to this remote node in its RIP
broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote
node will be propagated to other hosts through RIP
broadcasts.
No
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP
Direction. Options are Both, In Only, Out Only or None.
None
Version Press [SPACE BAR] and then [ENTER] to select the RIP
version. Options are RIP-1, RIP-2B or RIP-2M.
RIP-1
Table 13 Menu 11.3 Remote Node Network Layer Options (continued)
Field Description Example