User's Manual

Chapter 6 Remote Node setup 75
BCM50a Integrated Router Configuration — Advanced
2 In menu 11.1, make sure IP is among the protocols in the Route field.
3 Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select
Yes, then press [ENTER] to display Menu 11.3 – Remote Node Network
Layer Options.
Figure 19 Menu 11.3 – Remote Node Network Layer Options
Table 13 explains fields in Figure 19.
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Dynamic Ethernet Addr Timeout(min)=
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Table 13 Menu 11.3 Remote Node Network Layer Options
Field Description Example
IP Address
Assignment
Press [SPACE BAR] and then [ENTER] to select
Dynamic if the remote node is using a dynamically
assigned IP address or Static if it is using a static (fixed)
IP address. You will only be able to configure this in the
ISP node (also the one you configure in menu 4),all other
nodes are set to Static.
Dynamic
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet
Mask
Type the subnet mask assigned to the remote node.