User's Manual

Chapter 4 LAN setup 61
BCM50a Integrated Router Configuration — Advanced
Use the instructions in Table 9 to configure TCP/IP parameters for the LAN port.
IP Alias Setup
You must use menu 3.2 to configure the first network. Move the cursor to the Edit
IP Alias field, press [SPACE BAR] to choose Yes and press [ENTER] to
configure the second and third network.
Press [ENTER] to open Menu 3.2.1 - IP Alias Setup, as shown in Figure 15.
Table 9 LAN TCP/IP setup menu fields
Field Description Example
TCP/IP Setup:
IP Address Enter the IP address of your BCM50a Integrated
Router in dotted decimal notation.
192.168.1.1
(default)
IP Subnet Mask Your BCM50a Integrated Router automatically
calculates the subnet mask based on the IP
address that you assign. Unless you are
implementing subnetting, use the subnet mask
computed by the BCM50a Integrated Router.
255.255.255.0
RIP Direction Press [SPACE BAR] and then [ENTER] to select
the RIP direction. Options are: Both, In Only,
Out Only or None.
Both
(default)
Version Press [SPACE BAR] and then [ENTER] to select
the RIP version. Options are:
RIP-1, RIP-2B or RIP-2M.
RIP-1
(default)
Multicast IGMP (Internet Group Multicast Protocol) is a
network-layer protocol used to establish
membership in a Multicast group. The BCM50a
Integrated Router supports both IGMP version 1
(IGMP-v1) and version 2 (IGMP-v2). Press
[SPACE BAR] and then [ENTER] to enable IP
Multicasting or select None (default) to disable it.
None
Edit IP Alias The BCM50a Integrated Router supports three
logical LAN interfaces via its single physical
Ethernet interface with the BCM50a Integrated
Router itself as the gateway for each LAN
network. Press [SPACE BAR] to select Yes and
then press [ENTER] to display menu 3.2.1.
Yes