User's Manual

Chapter 3 WAN Setup 55

BCM50a Integrated Router Configuration — Advanced

Traffic redirect setup

Configure parameters that determine when the BCM50a Integrated Router

forwards WAN traffic to the backup gateway using Menu 2.2 - Traffic Redirect

Setup.

Edit Traffic

Redirect

Press [SPACE BAR] to select Yes or No.

Select No (default) if you do not want to configure this

feature.

Select Yes and press [ENTER] to configure Menu 2.2

— Traffic Redirect Setup.

Dial-Backup: Dial backup does not apply to all BCM50a Integrated

Router models.

Active Use this field to turn the dial-backup feature on (Yes)

or off (No).

Port Speed Press [SPACE BAR] and then press [ENTER] to

select the speed of the connection between the dial

backup port and the external device.

Available speeds are:

9600, 19200, 38400, 57600, 115200 or 230400 b/s.

115200

AT Command

String:

Init Enter the AT command string to initialize the WAN

device. Consult the manual of the WAN device

connected to your Dial Backup port for specific AT

commands.

at&fs0=0

Edit Advanced

Setup

To edit the advanced setup for the Dial Backup port,

move the cursor to this field; press the [SPACE BAR]

to select Yes and then press [ENTER] to go to Menu

2.1 — Advanced Setup.

Yes

After you complete this menu, press [ENTER] at the

prompt “Press ENTER to Confirm…” to save your

configuration, or press [ESC] at any time to cancel.

Table 6 Menu 2 WAN setup

Field Description Example