User's Manual

266 Appendix G Command Interpreter
N0115791
WAN Commands
The following chart lists and describes the wan commands. Each of these
commands must be preceded by wan when you use them.
Table 61 WAN Commands
Command Description
wan
adsl bert Displays ADSL ber.
cellcnt Displays the ADSL cell counter.
chandata Displays the ADSL operational mode
(standard) and ADSL channel data, line rate.
close Closes the ADSL line.
defbitmap Displays ADSL defect bitmap status.
dyinggasp Sends ADSL dyinggasp.
linedata far Shows ADSL far end noise margin and carrier
load information.
near Shows ADSL near end noise margin and
carrier load information.
open Opens the ADSL line.
opencmd Opens ADSL line with a specific standard.
opmode Shows the ADSL operational mode
(standard).
perfdata Shows performance information such as the
CRC,FEC, error seconds.
reset Resets the ADSL modem, and must reload the
modem code again.
status Displays ADSL status (ex: up, down or wait for
init).
version Shows the ADSL firmware version.
atm
vchunt