User's Manual

Appendix G Command Interpreter 261
BCM50a Integrated Router Configuration — Advanced
ikeDelete <rule index>
Deletes the specified IPSec rule.
policyEdit <rule index>
Edits the specified IP policy.
policySave
Saves the IP policy.
ipsecList
Displays a summary of the IPSec (phase
2) rules.
policyList
Displays the IP policies.
policyDelete <rule index>
Deletes the specified IP policy.
policyConfig
Uses these commands to configure an IP
policy for an IPSec office tunnel rule.
saIndex <rule index>
Binds the IP policy to an IPSec rule.
active <Yes|No>
Turns the IP policy on or off.
lcAddrStart <IP>
Sets the local starting IP address.
protocol <1:ICMP | 6:TCP
| 17:UDP>
Sets the IP policy’s protocol.
controlPing <Yes|No>
Turns control ping on or off.
controlPingAddr <IP>
Sets the control ping IP address.
lcAddrType <0:single |
1:range |
2:subnet>
Sets the local address type.
lcAddrEndMask <IP>
Sets the local ending IP address or
subnet mask.
lcPortStart <port>
Sets the local starting port number.
lcPortEnd <port>
Sets the local ending port number.
rmAddrType <0:single |
1:range |
2:subnet>
Sets the remote address type.
rmAddrStart <IP>
Sets the remote starting IP address.
rmAddrEndMask <IP>
Sets the remote ending IP address or
subnet mask.
rmPortStart <port>
Sets the remote starting port number.
rmPortEnd <port>
Sets the remote ending port number.
btNatActive <Yes | No>
Turns branch tunnel NAT address
mapping on or off.
Table 60 IPSec commands
Command Description