User's Manual

Appendix G Command Interpreter 253
BCM50a Integrated Router Configuration — Advanced
<iface> in [mode]
Sets the BCM50a Integrated Router to use
the RIP information it receives.
<iface> out
[mode]
Sets the BCM50a Integrated Router to
broadcast its routing table.
dialin_user [show|in|out|both
|none]
Shows the dial-in user RIP direction.
tcp status
Displays the TCP statistic counters.
telnet <host> [port]
Creates a Telnet connection to the specified
host.
tftp
support
Displays whether or not TFTP is supported.
stats
Displays the TFTP statistics.
traceroute <host> [ttl]
[wait] [queries]
Sends ICMP packets to trace the route of a
remote host.
xparent join <iface1>
[<iface2>]
Add iface2 to the iface1’s group.
break <iface>
Remove the specified interface from the
ipxparent group.
urlfilter
enable [0:no/1:yes]
Enables or disables content filtering.
exemptZone
display
Displays content filtering exempt zone
information.
actionFlags
[type(1-3)][enabl
e/disable]
Enables or disables content filtering exempt
zone action flags that determine to which IP
addresses content filtering applies.
add [ip1] [ip2]
Sets a range of IP addresses to be in the
exempt zone.
delete [ip1]
[ip2]
Removes a range of IP addresses from the
exempt zone.
reset
Returns the exempt zone settings to the
previous configuration.
customize
Uses the customize commands to configure
content filtering for trusted Web sites,
forbidden Web sites and keyword blocking.
display
Displays the content filtering customize action
flags.
Table 59 IP commands
Command Description