User's Manual

244 Appendix G Command Interpreter
N0115791
disp
Displays the error log.
online
Turns the error log online display on or
off.
load
Loads the log settings buffer. Use this
command before you configure the log
settings. Use sys logs save after
you configure the log settings.
mail
alertAddr [mail address]
Sends alerts to this e-mail address.
clearLog [0:no/1:yes]
Enables the switch to clear the log after
sending logs via e-mail.
display
Displays the logs and alerts mail
settings.
logAddr [mail address]
Sends logs to this e-mail address.
schedule display
Displays the mail schedule.
schedule hour [0-23]
Sets the hour to send logs.
schedule minute [0-59]
Sets the minute to send the logs.
schedule policy [0:full/
1:hourly/2:daily/3:weekly/
4:none]
Sets the mail schedule policy.
schedule week [0:sun/1:mon/
2:tue/3:wed/4:thu/5:fri/
6:sat]
Sets the day of the week to send
weekly logs.
server [domainName/IP]
Sets the domain name or IP address of
the mail server to which the logs are
sent.
subject [mail subject]
Sets the log e-mail’s subject.
auth
Enables or disables SMTP
authentication.
user
Sets the SMTP authentication
username.
passwd
Sets the SMTP authentication
password.
save
Saves the log settings from the buffer.
syslog
active [0:no/1:yes]
Enables or disables syslog logging.
Table 56 Sys commands
Command Description