User's Manual

124 Chapter 11 Filter configuration
N0115791
Figure 57 Menu 21.1.1.1 – TCP/IP Filter Rule
Table 25 describes how to configure your TCP/IP filter rule.
Menu 21.1.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 0 IP Source Route= No
Destination: IP Addr=
IP Mask=
Port #=
Port # Comp= None
Source: IP Addr=
IP Mask=
Port #=
Port # Comp= None
TCP Estab= N/A
More= No Log= None
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Table 25 TCP/IP Filter Rule Menu fields
Field Description Options
Active Press [SPACE BAR] and then [ENTER] to select
Yes to activate the filter rule or No to deactivate it.
Yes
No
IP Protocol Protocol refers to the upper layer protocol, for
example, TCP is 6, UDP is 17 and ICMP is 1. Type a
value between 0 and 255. A value of 0 matches ANY
protocol.
0-255
IP Source Route Press [SPACE BAR] and then [ENTER] to select
Yes to apply the rule to packets with an IP source
route option. Otherwise the packets must not have a
source route option. The majority of IP packets do
not have source route.
Yes
No
Destination
IP Address Enter the destination IP Address of the packet you
wish to filter. This field is ignored if it is 0.0.0.0.
0.0.0.0