User's Manual

42 Chapter 4 Connection and configuration procedures
N0060602N0060602
Startup Profile times and LED sequence
Table 10 provides details about the BCM system boot times and LED sequence using the Startup
Profile to configure system parameters.
Configuring the MBMs
You must configure the MBMs to function with your BCM system.
To configure the MBMs
1 Open BCM Element Manager and connect to your BCM system.
2 From the Configuration tab, click the Resources folder to expand it.
3 Select Telephony Resources from the Resources folder (see Figure 12).
Table 10 Startup Profile times and LED sequence
Duration
(minutes)
Cumulative
time
(minutes) Power LED Status LED Comments
2 2 Solid green Flashing green
46 Solid red off
2 8 Solid green Solid green Initial boot sequence complete
30 38 Solid red Solid green Startup Profile functioning. Duration
varies depending on selected
parameters.
2 40 Solid green Flashing green
Off (error)
Startup Profile is successfully applied.
If there is an error the remaining steps
are not completed.
4 44 Solid red off Duration varies based on selected
parameters.
2 46 Solid green Solid green Reboot complete and system is
functional.
Note: You can safely remove USB
device.
Note 1: If you use Element Manager to configure the parameters, the overall times are similar. Startup Profile enables
you to configure multiple parameters at once, rather than individually using Element Manager.
Note 2: To re-apply the Startup Profile, remove the applied keycode file by returning the system to factory defaults
using the BIT tool.
1 minute/MBM