User's Manual
Chapter 3 Physical installation 31
BCM 4.0 Installation Checklist and Quick Start Guide
• To connect the WAN card using the RJ-48C connector, insert the wide area network
(WAN) cable into the RJ-48C jack on the WAN card (see Figure 1 on page 13 and Figure 2
on page 14).
• To connect the WAN card using the DB26 connector, use an adapter cable to connect the
wide area network (WAN) cable to the DB26 connector on the WAN card. These adapter
cables are available from your BCM supplier (see Figure 1 on page 13 and Figure 2 on
page 14).
Refer to the BCM200/400 4.0 Installation and Maintenance Guide for information on adapter
cable pin-outs.
To connect the modem
1 Ensure the system is powered up before connecting this cable.
2 Insert a PSTN line into the line jack on the modem interface (see Figure 1 on page 13 and
Figure 2 on page 14).
Refer to the BCM200/400 4.0 Installation and Maintenance Guide for information on adapter
cable pin-outs.
Unpacking, placing, and wiring telephone hardware
Refer to the chapter “Installing telephones and peripherals” in the BCM200/400 4.0 Installation
and Maintenance Guide for more detailed information.
The following telephones are supported:
• Digital Phone 7000, 7100, 7208, 7316, 7316E, 7324
• Digital Phone 7406 Cordless Telephone system
• IP Phone 2001, 2002, 2004, 2007
• IP Phone 1120E, 1140E
• i2050 software phone
• WLAN handsets 2210, 2211, 2212
• IP Audio Conferencing Unit (ACU) 2033
To install telephones
1 Open the box for each telephone and check that you have all of the components listed below:
• telephone set
• power supply and power supply cable
• telephone cable
• installation instructions
2 Visually inspect the components for any damage.
3 Install the telephones as shown in the included installation instructions.
2 minutes
9 minutes/telephone