User's Manual

Chapter 3 Physical installation 23
BCM 4.0 Installation Checklist and Quick Start Guide
Table 7 Possible station MBM DIP switch settings
DS30
bus #
Station MBM positioning
DIP switch settings
(Single density)
DIP switch settings
(Double density)
Offsets
DSM16+
Offsets 0, 1
SDDFDD
DSM32+
Offsets 0, 1
SDDFDD
ASM 8/
GASM8
Offsets 0,
1, 2, 3
12 3
(offset)
45 6
(DS30 #)
12 3
(offset)
45 6
(DS30 #)
2
0 0 0 0 0*** on on on on on on off on on on on on
0
1 on on off on on on off on off on on on
1
1 2 on off on on on on off off on on on on
2
3 on off off on on on off off off on on on
3
3
0 0 0 0 0 on on on on on off off on on on on off
0
1 on on off on on off off on off on on off
1
1 2 on off on on on off off off on on on off
2
3 on off off on on off off off off on on off
3
4
0 0 0 0 0 on on on on off on off on on on off on
0
1 on on off on off on off on off on off on
1
1 2 on off on on off on off off on on off on
2
3 on off off on off on off off off on off on
3
5
0 0 0 0 0 on on on on off off off on on on off off
0
1 on on off on off off off on off on off off
1
1 2 on off on on off off off off on on off off
2
3 on off off on off off off off off on off off
3
6
0 0 0 0 0 on on on off on on off on on off on on
0
1 on on off off on on off on off off on on
1
1 2 on off on off on on off off on off on on
2
3** on off off off on on off off off off on on
3
7*
0 0 0 0 on on on off on off off on on off on off
0
1 on on off off on off off on off off on off
1
1 2 on off on off on off off off on off on off
2
3** on off off off on off off off off off on off
3
MBM set to offset 0 MBM set to offset 1 MBM set to offset 2 MBM set to offset 3
Each shaded square represents the amount of the DS30 bus, and the offset, which the MBM requires.
* If your system is configured with a 3/5 DS30 split, DS30 7 is not available to MBMs.
** ASM MBMs always use the single density DIP switch settings, with the appropriate offset.