User's Manual

18 Chapter 3 Physical installation
N0060602N0060602
To attach the rack-mount brackets
1 Place the BCM unit on a flat, clean surface.
2 Align the screw holes between the BCM unit and one of the rack-mount brackets.
3 Fasten the bracket to the BCM unit using four screws. Refer to Figure 4.
4 Repeat steps 2 and 3 for the other rack-mount bracket.
5 If the BCM system has an expansion unit, attach the rack-mount brackets to the expansion unit
in the same way as the main unit.
Figure 4 Attach the rack-mount bracket to the BCM400 main unit
To mount a BCM unit in an equipment rack
1 Determine the location in the rack where you want to install the BCM unit.
2 Position the BCM unit in the rack. Have an assistant hold the BCM unit.
3 Align the holes in the rack-mount bracket with the holes in the equipment rack rails.
4 Fasten the rack-mount brackets to the rack using four screws (see Figure 5).
Caution: Use only the screws supplied with the rack-mount bracket. Other screws
can damage the unit.
6 minutes/unit
The rack-mount brackets for
the BCM200 main unit and
expansion unit are installed in
a similar manner.
6 minutes/unit