User manual

Remote Gateway 9150 Installation and Administration Guide 313
January 2005 Administration
Ethernet Interface Statistics field descriptions
The following table describes the statistics found on the Ethernet Interface
Statistics screen:
Column Description
Channel Identifies the Ethernet device that the statistics on that
line apply to.
The valid values are is1.
LAN Drv Identifies the LAN driver used by the call.
Admin Identifies the administrative state of the port.
Valid values are 1 (Enabled) and 0 (Disabled).
Oper Identifies the operational state of the port.
Valid values are 1 (Up) and 0 (Down).
IfcType Identifies the interface type used by the call.
IfcNo Identifies the Ethernet interface used by the call.
The valid value is 1 (CLAN).
MTUlen Identifies the Maximum Transmission Unit for this
interface in bytes.
Speed Identifies the data rate of this interface in Mbps.
Rx Octet Identifies the number of bytes received on the given
channel since the statistics were last reset.
Rx Ucast Identifies the number of packets with a unicast
Ethernet address that directly matches the Ethernet
address of the identified unit. This statistic describes
the period of time since the statistics were last reset.
Rx Mcast Identifies the number of multicast packets received.
These packets can be broadcast MAC addresses for
protocols such as ARP, as well as multicast packets
for group-oriented transmissions such as IP Multicast.
This statistic describes the period of time since the
statistics were last reset.