User manual

266 Remote Gateway 9150 Installation and Administration Guide
Using Remote Gateway 9150 stations Standard 3.1
Placing outgoing locally controlled calls
To place outgoing locally controlled calls:
Note: You cannot use this procedure to place calls to the host PBX site. If you
try, you hear a reorder dial tone (a fast busy signal) and the following message
displays on your telephone display:
Release and Try Again
1 Do one of the following:
2 Dial a trunk access code, if required.
Result: The Remote Gateway 9150 unit obtains a free trunk and you hear
another dial tone.
Note: If a trunk is not available, you hear a reorder dial tone (a fast busy
signal) and the following message displays on the telephone display:
Release and Try Again
3 Dial the number of the party you want to call.
Result: Your local telephone service provider receives and processes the
dialed digits and rings the called party.
IF you are using THEN
an analog or ATA-equipped
station,
do the following:
a Pick up the handset.
Result: A connection is
established with the host PBX and
you hear a dial tone.
b Dial the Local Calling SPRE code.
Result: The connection is
switched to the Remote Gateway
9150 unit and you hear a dial tone.
a digital telephone, pick up the handset, and then press a
local call appearance key.
Result: A connection is established with
the Remote Gateway 9150 unit and you
hear a dial tone.