User manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 11 High-speed ATM configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 11-13
----End
11.4.3 Configuring the service type of a PVP
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface atm interface-number.subinterface
The ATM sub-interface view appears.
Step 3 Run:
pvp vpi
The command creates the PVP and the PVP view appears.
You can only configure the PVP on the ATM sub interface view.
Step 4 Choose the following steps to configure the service type of the PVP and related rate
parameters.
z
Run the service cbr output-pcr [ cdvt cdvt-value ] command to configure the service
type as CBR.
z
Run the service ubr command to configure the service type as UBR.
z
Run the service vbr-nrt output-pcr output-scr output-mbs [ cdvt cdvt-value ] command
to configure the service type as VBR-NRT.
z
Run the service vbr-rt output-pcr output-scr output-mbs [ cdvt cdvt-value ] command to
configure the service type as VBR-RT.
By default, the service type of PVP is UBR.
----End
11.4.4 Checking the configuration
Run the following commands to check the configuration.
Action Command
Check the configuration and
status of the ATM interface.
display interface atm [ interface-number
[ .subinterface ] ] [ | { begin | exclude | include }
regular-expression ] [ interface-type ]
Check information about the
PVC.
display atm pvc-info [ interface interface-type
interface-number [ .subinterface ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Check information about the
PVP.
display atm pvp-info [ interface interface-type
interface-number[.subinterface ] [ pvp vpi ] ]