User manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 11 High-speed ATM configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 11-11
On the same ATM (sub) interface, you can configure only a single PVC with InARP.
----End
11.3.3 Checking the configuration
Run the following commands to check the previous configuration.
Action Command
Check the configuration and
status of the ATM interface or
sub-interface.
display interface atm [ interface-number
[ .subinterface ]] [ | { begin | exclude | include }
regular-expression ] [ interface-type ]
Check information about the
PVC.
display atm pvc-info [ interface interface-type
interface-number [ .subinterface ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Check information about the
PVC mapping.
display atm map-info [ interface interface-type
interface-number [ .subinterface ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
11.4 Configuring the service type of PVC and PVP
11.4.1 Establishing the configuration task
Applicable environment
Based on the practical networking requirements, you need to specify the service type of PVC
and PVP.
Preconfiguration tasks
Before configuring the service types of a PVC or a PVP, complete the following tasks:
z
Configuring physical attributes for the ATM interface
z
Configuring an IP address and mask for the ATM interface or sub-interface
z
Creating a PVC and configuring application modes
Data preparation
To configure the service type of PVC or PVP, you need the following data.
No. Data
1 Number of the ATM interface or sub-interface
2 IP address and mask of the ATM interface or sub-interface
3 PVC or PVP name (optional), the network VPI and VCI